Day 7 - Clean Up and Seat Stands

Today I just tried to clean the garage and build some stands for the bucket seats. Because the seats seem to be in pretty good condition, I wanted to protect them. These car seats bolt right to the floor I made some stands so the studs wouldn’t get damaged.

First I took a piece of plywood and cut it to the length and width of the foot print of the seat.

I then set it on the studs then marked where the studs are on the wood. I drilled out the holes and made sure it fit.

I then attached a couple of 2X4 s to the bottom so that the seat can sit on the floor without sitting on the studs.